Setting The Mask Value For Mpls Rate-Limit Profiles; Setting The Mask Value For Ip And Ipv6 Rate-Limit Profiles; Setting The Peak Burst For Two-Rate Rate-Limit Profiles - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual
Software for e series broadband services routers policy management configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04:
- Reference manual (284 pages) ,
- Configuration manual (632 pages)
Table of Contents
Advertisement
JunosE 11.3.x Policy Management Configuration Guide
Setting the Mask Value for MPLS Rate-Limit Profiles
Related
Documentation
Setting the Mask Value for IP and IPv6 Rate-Limit Profiles
Related
Documentation
Setting the Peak Burst for Two-Rate Rate-Limit Profiles
88
You can use the exp-mask command to set the mask value used for MPLS rate-limit
profiles, in the range 1–255. The no version restores the default value, 7. This command
is associated with the committed-action, conformed-action, and exceeded-action
commands.
Issue the exp-mask command from Rate Limit Profile Configuration mode.
host1(config-rate-limit-profile)#exp-mask 5
mask-val
You can use the mask-val command to set the mask value used for IP and IPv6 rate-limit
profiles.5.2.0b1 ID-2170 Use the mask values to set the appropriate bits in the ToS field
of the IP packet header or in the traffic class field of the IPv6 packet header. The no
version restores the default value, 255. This command is associated with the
committed-action, conformed-action. and exceeded-action commands.
Issue the mask-val command from Rate Limit Profile Configuration mode:
host1(config-rate-limit-profile)#mask-val 0xFC
mask-val
For two-rate rate-limit profiles only, you can use the peak-burst command to set the
peak burst in bytes for a rate-limit profile; range is 1–4294967295. Use to set the peak
burst in milliseconds for a rate-limit profile; range is 1–10000. The no version restore the
default value, 100 ms or 8192 bytes (whichever is more).
When you specify a nonzero value for the peak rate, the peak burst size is automatically
calculated for a 100-ms burst as described for the peak-rate command. If the calculated
peak burst size is less than the default value of 8192 bytes, the default value is used.
NOTE: We recommend that you do not configure a committed or peak burst
size smaller than the MTU of the interface. Doing so causes large packets to
be dropped even when they are transmitted at a very low rate.
Issue the peak-burst command in Rate Limit Profile Configuration mode to set the
peak burst in bytes:
host1(config-rate-limit-profile)#peak-burst 96256
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 and is the answer not in the manual?