Example: Arbitrary Interface Groups Hierarchical Policy Configuration - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x Policy Management Configuration Guide

Example: Arbitrary Interface Groups Hierarchical Policy Configuration

140
host1(config)#rate-limit-profile VIDEO_RATE two-rate hierarchical
host1(config-rate-limit-profile)#committed-rate 1000000
host1(config-rate-limit-profile)#committed-action transmit conditional
host1(config-rate-limit-profile)#exit
host1(config)#rate-limit-profile DATA_RATE two-rate hierarchical
host1(config-rate-limit-profile)#committed-rate 5000000
host1(config-rate-limit-profile)#committed-action transmit conditional
host1(config-rate-limit-profile)#exit
host1(config)#policy-parameter A hierarchical
host1(config-policy-parameter)#exit
host1(config)#policy-parameter B hierarchical
host1(config-policy-parameter)#exit
host1(config)#ip policy-list IP_POL1
host1(config-policy-list)#classifier-group VIDEO_CLACL external parent-group EPG1
parameter A
host1(config-policy-list-classifier-group)#rate-limit-profile VIDEO_RATE
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#classifier-group * external parent-group EPG2
parameter B
host1(config-policy-list-classifier-group)#rate-limit-profile DATA_RATE
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#exit
In all users' records in RADIUS, specify the ingress policy name IP_POL1. However, be
3.
sure to specify the policy parameter through the profile.
host1(config)#profile PPPOE_PROF1
host1(config-profile)#ip policy-parameter hierarchical A vlan
host1(config-profile)#ip policy-parameter hierarchical B ethernet
host1(config-profile)#exit
host1(config)#interface fastEthernet 3/0.1
host1(config-interface)#vlan id 1
host1(config-interface)#encapsulation pppoe
host1(config-interface)#profile PPPOE_PROF1
host1(config-interface)#pppoe auto-configure
host1(config-interface)#exit
In this example, there are four terminated sessions and their corresponding IP interfaces
are I1, I2, I3, and I4. Figure 14 on page 141 shows the following:
Sessions I1 and I2 are for the same subscriber: I1 carries only voice traffic and I2 carries
all other traffic for this subscriber
Sessions I3 and I4 are for another subscriber.
Voice traffic has a contracted minimum of 64 Kbps, but the combined voice and other
traffic for each subscriber has a contracted maximum of 1 Mbps.
Interfaces I1-I4 are interfaces where you can attach policies.
Copyright © 2010, Juniper Networks, Inc.