Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 170

JunosE 11.3.x Policy Management Configuration Guide
146
host1(config-policy-classifier-group)#forward
host1(config-policy-classifier-group)#exit
host1(config-policy)#exit
Attach an IP policy P at interface atm5/0.1 by specifying a different reference-rate
6.
value.
host1(config)#interface atm 5/0.1
host1(config-if)#ip policy-parameter reference-rate refRlpRate 5000000
host1(config-if)#ip policy input P stats enabled
Attach an IP policy P at interface atm5/0.2 to use the default value.
7.
host1(config)#interface atm 5/0.2
host1(config-if)#ip policy input P stats enabled
Display the policy list.
8.
host1#show policy-list
Policy Table
------ -----
IP Policy P
Administrative state: enable
Reference count:
Classifier control list: cl1, precedence 100, external parent-group
epg1 parameter A
forward
Referenced by interface(s):
ATM5/0.1 input policy, statistics disabled, virtual-router default
ATM5/0.2 input policy, statistics enabled, virtual-router default
Referenced by profile(s):
None
Referenced by merge policies:
None
Display the interface configuration to verify the reference rate (committed rate and
9.
peak rate) being different for both interface attachments (only the policy-related
section of the output is shown).
host1#show ip interface atm 5/0.1
IP policy input P
classifier-group data entry 1, external parent-group epg1
aggregate-node forwarding
0 packets, 0 bytes
forward
external parent-group epg1 aggregate-node forwarding
rate-limit-profile rlpData
committed rate: 500000 bps, committed burst: 8192 bytes (default)
peak rate: 5000000 bps, peak burst: 62500 bytes (default)
committed: 0 packets, 0 bytes, action: transmit conditional
conformed: 0 packets, 0 bytes, action: transmit conditional
exceeded:
unconditional: 0 packets, 0 bytes
saturated: 0 packets, 0 bytes
2
0 packets, 0 bytes, action: drop
Copyright © 2010, Juniper Networks, Inc.