Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 65

Original Policy Attachment
ip policy-list plOne
ip classifier-list clOne
Forward
ip classifier-list clTwo
Forward
ip classifier-list clThree
Forward
classifier-list *
Filter
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
For example, when you replace a policy attachment that references the original policy-list
plOne with a new attachment referencing policy-list plTwo, the existing statistics for the
classifier group referencing clOne and the default classifier group are saved.
New Policy Attachment
ip policy-list plTwo
ip classifier-list clOne
Forward
ip classifier-list clFour
Forward
ip classifier-list clFive
Forward
classifier-list *
Filter
You can use the merge keyword to enable merging of multiple policies to form a single
policy.
host1(config)#vlan policy input VlanPolicy33 statistics enabled preserve
host1(config)#ipv6 policy secondary-input my-policy
To assign the policy list named routeForXYZCorp with statistics enabled to the ingress
IP interface over an ATM subinterface:
host1(config)#interface atm 12/0.1
host1(config)#ip policy input routeForXYZCorp statistics enabled
To create an L2TP profile that applies the policy list routeForABCCorp to the egress of
an interface:
host1(config)#profile bostonProfile
host1(config)#l2tp policy output routeForABCCorp
atm policy
frame-relay policy
gre-tunnel policy
ip policy
ipv6 policy
l2tp policy
mpls policy
Chapter 4: Creating Classifier Groups and Policy Rules
Comment
-
statistics from plOne are saved
-
-
-
-
-
statistics from plOne are saved
-
41