Applying Policy Lists To Interfaces And Profiles Overview - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Related
Documentation

Applying Policy Lists to Interfaces and Profiles Overview

Copyright © 2010, Juniper Networks, Inc.
Classifier Groups and Policy Rules Overview on page 27
Creating Rate-Limit Profiles on page 73
Monitoring Policy Management Overview on page 173
aggregation-node
classifier-group
ip policy-parameter hierarchical
ip policy-parameter reference-rate
ipv6 policy-parameter hierarchical
ipv6 policy-parameter reference-rate
l2tp policy-parameter hierarchical
l2tp policy-parameter reference-rate
mpls policy-parameter hierarchical
mpls policy-parameter reference-rate
next-parent
parent-group
policy-parameter hierarchical
You can assign a policy list to supported interfaces and profiles. Policy lists are supported
on Frame Relay, IP, IPv6, GRE tunnel, MPLS layer 2, and VLAN interfaces. You can also
specify IP, IPv6, and L2TP policies in profiles to assign a policy list to an interface. In either
case, you can enable or disable the recording of statistics for bytes and packets affected
by the assigned policy.
You can also preserve statistics when you attach a new policy that has a classifier list
that is the same for both the original and the new policy attachments.
You can use policy commands to assign an ATM, Frame Relay, GRE tunnel, IP, IPv6,
MPLS, or VLAN policy list to an interface. Also, you can use them to specify an IP, IPv6,
or L2TP policy list to a profile, which then assigns the policy to the interfaces to which
the profile is attached
Chapter 4: Creating Classifier Groups and Policy Rules
39