Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 101

Software for e series broadband services routers policy management configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04:
Table of Contents

Advertisement

Copyright © 2010, Juniper Networks, Inc.
In Policed Packets 0, Bytes 0
In Error Packets 0
In Invalid Source Address Packets 0
In Discarded Packets 0
Out Forwarded Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Routed Packets 0, Bytes 0
Out Scheduler Dropped Packets 0, Bytes 0
Out Policed Packets 0, Bytes 0
Out Discarded Packets 0
IP policy input P
classifier-group data entry 1
0 packets, 0 bytes
rate-limit-profile rlpData
committed rate: 10000 bps, committed burst: 125 bytes
peak Rate: 100000 bps, peak burst: 1875 bytes
committed: 0 packets, 0 bytes, action: transmit
conformed: 0 packets, 0 bytes, action: transmit
exceeded:
classifier-group voice entry 1
0 packets, 0 bytes
rate-limit-profile rlpVoice
committed rate: 64000 bps, committed burst: 100000 bytes
peak Rate: 100000 bps, peak burst: 1875 bytes
committed: 0 packets, 0 bytes, action: transmit
conformed: 0 packets, 0 bytes, action: transmit
exceeded:
classifier-group video entry 1
0 packets, 0 bytes
rate-limit-profile rlpVideo
committed rate: 70000 bps, committed burst: 875 bytes
peak Rate: 100000 bps, peak burst: 1875 bytes
committed: 0 packets, 0 bytes, action: transmit
conformed: 0 packets, 0 bytes, action: transmit
exceeded:
To configure a policy-parameter at an interface with the increase keyword:
Create policy list P2.
1.
host1(config)#ip policy-list P2
host1(config-policy)#classifier-group data2
host1(config-policy-classifier-group)#rate-limit-profile rlpData
host1(config-policy-classifier-group)#exit
host1(config-policy)#exit
Attach IP Policy P2 at interface atm5/0.2 with the merge keyword.
2.
host1(config)#interface atm 5/0.2
host1(config-If)#ip policy-parameter reference-rate refRlpRate 100000
This increases from 0.
host1(config)#ip policy-parameter reference-rate refRlpRate increase 100000
This increases from the existing 100000.
host1(config)#ip policy input P2 merge
Verify the configuration.
3.
0 packets, 0 bytes, action: drop
0 packets, 0 bytes, action: drop
0 packets, 0 bytes, action: drop
Chapter 5: Creating Rate-Limit Profiles
77

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 and is the answer not in the manual?

This manual is also suitable for:

Junose 11.3

Table of Contents