Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 78

JunosE 11.3.x Policy Management Configuration Guide
Table 9: Ascend-Data-Filter Attribute for an Input Policy on an IPv6 Interface (continued)
Action or Classifier
Destination IPv6 prefix
Protocol
Established
Source port
Destination port
Source port qualifier
Destination port qualifier
Reserved
54
Hex Value
00
06
00
2328
0000
03
00
0000
Use the show classifier-list and show policy-list commands to view information about
the configured input and output policies:
host1#show classifier-list
IPv6 clout_1800020_00.1 udp source-address 3001:82ab:1020:87ec::/64
destination-host
2001:82ab:1020:87ec:1234:917:3415:12 destination-port eq 3090
IPv6 clin_1800020_01.1 tcp source-host 2001:82ab:1020:87ec:1234:917:3415:12
source-port gt 9000
host1#show policy-list
IPv6 Policy plout_ipv6_1800020
Administrative state: enable
Reference count:
Classifier control list: clout_1800020_00, precedence 100
filter
Referenced by interface(s):
GigabitEthernet10/0.2
default
Referenced by profile(s):
None
Referenced by merged policies:
None
IPv6 Policy plin_ipv6_1800020
Administrative state: enable
Reference count:
Actual Value
0
TCP
None
9000
None
Greater than
None
None
Classifier Control List Table
---------- ------- ---- -----
Policy Table
------ -----
1
output policy, statistics enabled, virtual-router
1
Copyright © 2010, Juniper Networks, Inc.