Monitoring Policy Management; Monitoring Policy Management Overview - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

CHAPTER 9

Monitoring Policy Management

Monitoring Policy Management Overview

Copyright © 2010, Juniper Networks, Inc.
This chapter explains how to set a statistics baseline and use the show command to
display your policy configuration and monitor policy statistics.
This chapter discusses the following topics:
Monitoring Policy Management Overview on page 173
Setting a Statistics Baseline for Policies on page 174
Monitoring the Policy Configuration of ATM Subinterfaces on page 175
Monitoring Classifier Control Lists on page 176
Monitoring Color-Mark Profiles on page 179
Monitoring Control Plane Policer Information on page 179
Monitoring the Policy Configuration of Frame Relay Subinterfaces on page 180
Monitoring GRE Tunnel Information on page 181
Monitoring Interfaces and Policy Lists on page 183
Monitoring the Policy Configuration of IP Interfaces on page 185
Monitoring the Policy Configuration of IPv6 Interfaces on page 189
Monitoring the Policy Configuration of Layer 2 Services over MPLS on page 193
Monitoring External Parent Groups on page 195
Monitoring Policy Lists on page 196
Monitoring Policy List Parameters on page 202
Monitoring Rate-Limit Profiles on page 203
Monitoring the Policy Configuration of VLAN Subinterfaces on page 205
Packet Flow Monitoring Overview on page 206
You can set a statistics baseline and use the show command to display your policy
configuration and monitor policy statistics. When you set baseline statistics, you can
retrieve statistics beginning at the time when the baselining is set. The policy log rule
provides a way to monitor a packet flow by capturing a sample of the packets that satisfy
the classification of the rule in the system log. See JunosE System Event Logging Reference
Guide for information about logging.
173