Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 279

Software for e series broadband services routers policy management configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04:
Table of Contents

Advertisement

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
You can use the show snmp secure-log command to display the captured secure logs.
Secure logs are stored in a string format similar to SNMP trap audit logs. You can use the
snmp-server clear secure-log command to reset the secure logs.
The secure log configuration and data are not persistent. Secure audit logs are not
available after a warm or cold restart of the SNMP agent, because the SNMP agent does
not store the secure logs in NVS. The SNMP agent can store a maximum of 100 secure
logs before overwriting the logs.
To enhance security, you can configure and display the secure audit logs only through
the CLI. You cannot use SNMP to configure and display the logs. Secure trap logs are not
populated in the notification logs MIB. From the perspective of the notification log MIB,
secure traps do not exist.
snmp-server clear secure-log
snmp-server secure-log
show snmp secure-log
show snmp trap
Chapter 13: Managing Packet Mirroring
255

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 and is the answer not in the manual?

This manual is also suitable for:

Junose 11.3

Table of Contents