Creating Policy Lists For Gre Tunnels - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x Policy Management Configuration Guide
Related
Documentation

Creating Policy Lists for GRE Tunnels

20
Frame relay policy input frInputPolicy
classifier-group frMatchDeSet entry 1
5 packets, 660 bytes
color red
Display the classifier list.
5.
host1#show classifier-list detailed
Frame relay Classifier Control List frMatchDeSet
Reference count:
Entry count:
Classifier-List frMatchDeSet Entry 1
DE Bit:
Display the policy lists.
6.
host1#show policy-list
Frame relay Policy frOutputPolicy
Administrative state: enable
Reference count:
Classifier control list: frMatchDeSet, precedence 100
mark-de 1
Frame relay Policy frInputPolicy
Administrative state: enable
Reference count:
Classifier control list: frGroupA, precedence 100
color red
frame-relay policy-list
The following example creates a GRE tunnel policy list named routeGre50. For information
about creating the CLACL used in this example, see the previous sections.
Create the policy list routeGre50.
1.
host1(config)#gre-tunnel policy-list routeGre50
Create the classification group for the CLACL named gre8 and assign a precedence
2.
of 150 to it.
host1(config-policy-list)#classifier-group gre8 precedence 150
host1(config-policy-list-classifier-group)#
Add two rules for traffic based on the CLACL named gre8: one rule to color packets
3.
as red, and a second rule that specifies the ToS DS field value to be assigned to the
packets.
Classifier Control List Table
---------- ------- ---- -----
1
1
1
Policy Table
------ -----
0
0
Copyright © 2010, Juniper Networks, Inc.