Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 135

Copyright © 2010, Juniper Networks, Inc.
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
ATM5/0.1 input policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
p1
p2
p3
Detach p2 from atm 5/0.1. A new merge policy mpl_8 is created, which is a combination
13.
of p1 and p3. The previous merge policy mpl_7 is detached and, because this policy
has no attachments, it is deleted.
host1(config)#interface atm 5/0.1
host1(config-subif)#no ip policy input p2
host1(config-subif)#exit
Display policies to verify that the mpl_7 is removed and the new merge policy mpl_8
14.
is created.
host1#show policy-list
IP Policy p1
Administrative state: enable
Reference count:
Classifier control list: C2, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
Referenced by interfaces:
None
Referenced by profiles:
None
Referenced by merge policies:
mpl_5
mpl_8
IP Policy p2
Administrative state: enable
Reference count:
Classifier control list: C3, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 20.1.1.1, order 100, rule 3 (active)
Classifier control list: *, precedence 1000
forward
Policy Table
------ -----
2
1
Chapter 6: Merging Policies
111