Monitoring Packet Mirroring; Monitoring Packet Mirroring Overview - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

CHAPTER 14

Monitoring Packet Mirroring

Monitoring Packet Mirroring Overview

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Packet mirroring enables you to send a copy of a packet to an external host for analysis.
Packet mirroring has many uses, including traffic debugging and troubleshooting user
networking problems.
This chapter contains the following topics:
Monitoring Packet Mirroring Overview on page 257
Monitoring CLI-Based Packet Mirroring on page 258
Monitoring the Packet Mirroring Configuration of IP Interfaces on page 259
Monitoring Failure Messages for Secure Policies on page 260
Monitoring Packet Mirroring Triggers on page 261
Monitoring Packet Mirroring Subscriber Information on page 262
Monitoring RADIUS Dynamic-Request Server Information on page 263
Monitoring Secure CLACL Configurations on page 264
Monitoring Secure Policy Lists on page 267
Monitoring Information for Secure Policies on page 268
Monitoring SNMP Secure Packet Mirroring Traps on page 269
Monitoring SNMP Secure Audit Logs on page 271
This topic describes the commands you can use to view your CLI-based and
RADIUS-based packet mirroring environments.
Use the baseline radius dynamic-request command in RADIUS-based packet mirroring
to set a statistics baseline for packet mirroring–related RADIUS statistics. The E Series
router implements the baseline by reading and storing the statistics at the time the
baseline is set and then subtracting this baseline when you retrieve baseline-relative
statistics. Use the delta keyword with the show radius statistics command to show
baselined statistics.
baseline radius dynamic-request
clear mirror log
257