Creating Policy Lists For L2Tp; Creating Policy Lists For Mpls - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x Policy Management Configuration Guide
Related
Documentation

Creating Policy Lists for L2TP

Related
Documentation

Creating Policy Lists for MPLS

24
exception http-redirect
ipv6 policy-list
exception http-redirect
The following example creates an L2TP policy list.
Create the policy list routeForl2tp.
1.
host1(config)#l2tp policy-list routeForl2tp
host1(config-policy-list)#
Create the classification group to match all packets.
2.
host1(config-policy-list)#classifier-group *
host1(config-policy-list-classifier-group)#
Add a rule to color packets as red, and a second rule that uses the rate-limit profile
3.
l2tpRLP10.
host1(config-policy-list-classifier-group)#color red
host1(config-policy-list-classifier-group)#rate-limit-profile l2tpRLP10
Exit Policy List Configuration mode to save the configuration.
4.
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#exit
host1(config)#
Display the policy list.
5.
host1#show policy-list routeForl2tp
L2TP Policy routeForl2tp
Administrative state: enable
Reference count:
Classifier control list: *, precedence 100
color red
rate-limit-profile l2tpRLP20
l2tp policy-list
The following example creates an MPLS policy list.
Create the policy list routeForMpls.
1.
host1(config)#mpls policy-list routeForMpls
host1(config-policy-list)#
Policy Table
------ -----
0
Copyright © 2010, Juniper Networks, Inc.