Figure 12: Interface Stack For Aggregate Rate Limit - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x Policy Management Configuration Guide
138
All users can send a maximum of 1 Mbps video traffic each, but the total bandwidth
for all video traffic combined is 1.5 Mbps for a specific VLAN.
Similarly, all users can send a maximum of 5 Mbps data traffic, but the sum of all data
traffic on an Ethernet port is 10 Mbps. Interfaces I1-I4 are interfaces where you can
attach policies.

Figure 12: Interface Stack for Aggregate Rate Limit

This example uses the following:
At I1, I2, I3, I4:
Classified Video Flow. VIDEO_RATE, Committed Rate: 1 Mbps
Peak Rate: 0 Mbps
Committed Action: transmit conditional
Conformed Action: drop
Exceeded Action: drop
At I1, I2, I3, I4:
Classified Data Flow. DATA_RATE, Committed Rate: 5 Mbps
Peak Rate: 0 Mbps
Committed Action: transmit conditional
Conformed Action: drop
Exceeded Action: drop
All classified video flow policers over each VLAN interface feed into a single policer
with the following configuration:
VIDEO_AGG, Committed Rate: 1.5 Mbps
Peak Rate: 0 Mbps
Committed Action: transmit final
Conformed Action: drop
Exceeded Action: drop
Copyright © 2010, Juniper Networks, Inc.