Figure 13: Aggregate Rate Limit For Nonvoice Traffic Configuration - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual
Software for e series broadband services routers policy management configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04:
- Reference manual (284 pages) ,
- Configuration manual (632 pages)
Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
All classified data flow policers over each Ethernet port feed into a single policer with
the following configuration:
DATA_AGG, Committed Rate: 10 Mbps
Peak Rate: 0 Mbps
Committed Action: transmit final
Conformed Action: drop
Exceeded Action: drop
Policy IP_POL1 is attached to I1, I2, I3, and I4
Figure 13: Aggregate Rate Limit for Nonvoice Traffic Configuration
Create a rate limit that can be shared across all video streams. Create an external
1.
parent group to hold this rate limit.
host1(config)#rate-limit-profile VIDEO_AGG two-rate hierarchical
host1(config-rate-limit-profile)#committed-rate 1500000
host1(config-rate-limit-profile)#committed-action transmit final
host1(config-rate-limit-profile)#exit
host1(config)#parent-group EPG1
host1(config-parent-group)#rate-limit-profile VIDEO_AGG
host1(config-parent-group)#exit
Create a policy list to attach to all IP sessions.
2.
Chapter 7: Creating Hierarchical Policies for Interface Groups
139
Advertisement
Table of Contents
