Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 138

JunosE 11.3.x Policy Management Configuration Guide
114
Referenced by profiles:
None
Referenced by merge policies:
mpl_5
IP Policy p3
Administrative state: enable
Reference count:
Classifier control list: C1, precedence 80
color yellow
Classifier control list: C4, precedence 900
color red
Referenced by interfaces:
ATM5/0.1 input policy, statistics disabled, virtual-router default
Referenced by profiles:
None
Referenced by merge policies:
None
IP Policy mpl_5
Administrative state: enable
Reference count:
Classifier control list: C2, precedence 10
filter
Classifier control list: C3, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
next-hop 20.1.1.1, order 100, rule 3 (reachable)
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
ATM5/0.2 output policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
p1
p2
Detach p3 from atm 5/0.1.
17.
host1(config)#interface atm 5/0.1
host1(config-subif)#no ip policy input p3
host1(config-subif)#exit
Detach p1 from atm 5/0.2. Merge policy mpl_5 is detached and deleted and only p2
18.
is now attached.
host1(config)#interface atm 5/0.2
host1(config-subif)#no ip policy output p1
host1(config-subif)#exit
Detach p2 from atm 5/0.2.
19.
1
1
Copyright © 2010, Juniper Networks, Inc.