Table 42: Show Policy-List Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x Policy Management Configuration Guide
Meaning
200
host1#show policy-list P1
IP Policy P1
Administrative state: enable
Reference count:
Classifier control list: A, precedence 100, parent-group X
rate-limit-profile A
mark profile A
Classifier control list: B, precedence 100, parent-group X
rate-limit-profile B
mark profile B
Classifier control list: *, precedence 100, parent-group Z
mark profile D
forward
Parent group: X, parent-group Z
rate-limit-profile X
Parent group: Z
rate-limit-profile Z
Referenced by interface(s):
SERIAL4/0 input policy, statistics disabled, virtual-router default
SERIAL4/1 input policy, statistics disabled, virtual-router default
Referenced by profile(s):
No profile references
Table 42 on page 200 lists the show policy-list command output fields.

Table 42: show policy-list Output Fields

Field Name
Policy
Administrative state
Reference count
Atm cell mode
Referenced by interfaces
Policy Table
------ -----
2
Field Description
Name of the policy list.
For SNMP use; state is enabled when the policy
list is created. Users modifying the policy list
commands via telnet see the state as disabled.
Modifications of a policy are not applied to an
interface until the administrative state is first
disabled and then reenabled.
Number of attachments to interfaces or profiles.
An asterisk enclosed in parenthesis (*), if
displayed, denotes that the policy contains
inactive references to interfaces. The absence
of an asterisk denotes that all the attachments
of this policy to the specified number of
interfaces are active.
State of mode for ATM cell tax used in rate
calculations.
List of interfaces to which policy is attached and
is active; indicates whether the attachment is at
input or output of interface.
Copyright © 2010, Juniper Networks, Inc.