Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 223

Copyright © 2010, Juniper Networks, Inc.
To display component policies:
host1#show policy-list mpl_10
IP Policy mpl_10
Administrative state: enable
Reference count:
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
next-hop 20.1.1.1, order 100, rule 3 (reachable)
Classifier control list: C2, precedence 10
filter
Classifier control list: C3, precedence 10
filter
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
ATM5/0.1 input policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
comp_p1
comp_p3
To display the configuration of an IP policy list that contains inactive references to the
interface to which it is attached:
host1#show policy-list pv4
IP Policy pv4
Administrative state: enable
Reference count:
Classifier control list: cv4, precedence 100
forward
Classifier control list: *, precedence 100
filter
Referenced by interface(s):
GigabitEthernet12/1.0
default
Referenced by profile(s):
None
Referenced by merged policies:
None
To display rate limit hierarchy in one policy:
Chapter 9: Monitoring Policy Management
Policy Table
------ -----
1
Policy Table
------ -----
2 (*)
input policy, statistics disabled, virtual-router
199