Monitoring The Policy Configuration Of Frame Relay Subinterfaces; Table 34: Show Control-Plane Policer Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x Policy Management Configuration Guide
Meaning
Related
Documentation

Monitoring the Policy Configuration of Frame Relay Subinterfaces

Purpose
Action
180
Protocol
----------------------------- ------- ----- ------ ---------- ----------
PppEchoRequest
PppEchoReply
PppEchoReplyFast
PppControl
AtmControl
AtmOam
AtmDynamicIf
AtmInverseArp
FrameRelayControl
FrameRelayArp
PppoeControl
PppoePppConfig
EthernetArp
EthernetArpMiss
EthernetLacp
EthernetDynamicIf
Table 34 on page 180 lists the show control-plane policer command output fields.

Table 34: show control-plane policer Output Fields

Field Name
Protocol
Enabled
Rate (pps)
Burst Size (pkts)
Packets Committed
Packets Exceeded
show control-plane policer
Display information about a subinterface's Frame Relay policy lists.
To display information about Frame Relay policy lists:
host1#show frame-relay subinterface
Frame relay sub-interface SERIAL5/0:1/1.1, status is up
Number of sub-interface down transitions is 0
Time since last status change 03:04:59
No baseline has been set
In bytes: 660
In frames: 5
Rate Size Packets
Enabled (pps) (pkts) Committed
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
false 50 50
Field Description
Name of the protocol
True or False
Rate, in packets per second in the range
0–10000
Burst size, in packets, in the range 0–10000
Number of packets committed
Number of packets exceeded
Out bytes: 660
Out frames: 5
Copyright © 2010, Juniper Networks, Inc.
Packets
Exceeded
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0