Creating Policy Lists For Ip - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Related
Documentation

Creating Policy Lists for IP

Copyright © 2010, Juniper Networks, Inc.
host1(config-policy-list-classifier-group)#color red
host1(config-policy-list-classifier-group)#mark dsfield 20
host1(config-policy-list-classifier-group)#
Exit Policy List Configuration mode to save the configuration.
4.
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#exit
host1(config)#
Display the policy list.
5.
host1#show policy-list routeGre50
GRE Tunnel Policy routeGre50
Administrative state: enable
Reference count:
Classifier control list: gre8, precedence 150
color red
mark dsfield 20
gre-tunnel policy-list
The following example creates an IP policy list named routeForABCCorp. For information
about creating the CLACLs and rate-limit profile used in this example, see the previous
sections.
Create the policy list routeForABCCorp.
1.
host1(config)#ip policy-list routeForABCCorp
host1(config-policy-list)#
Create the classification group for the CLACL named ipCLACL10 and assign the
2.
precedence to the classification group.
host1(config-policy-list)#classifier-group ipCLACL10 precedence 75
host1(config-policy-list-classifier-group)#
Add a rule that specifies a group of forwarding solutions based on classifier list
3.
ipCLACL10.
host1(config-policy-list-classifier-group)#forward next-hop 192.0.2.12 order 10
host1(config-policy-list-classifier-group)#forward next-hop 192.0.100.109
order 20
host1(config-policy-list-classifier-group)#forward next-hop 192.120.17.5 order 30
host1(config-policy-list-classifier-group)#forward interface ip 3/1 order 40
Add a rule that sets a ToS byte value of 125 for packets based on classifier list
4.
ipCLACL10.
host1(config-policy-list-classifier-group)#mark tos 125
Add a rule that uses rate-limit profile ipRLP25.
5.
Policy Table
------ -----
0
Chapter 3: Creating Policy Lists
21