Ip Http Authentication - Dell Networking 7048 Reference Manual

User Guidelines
The PowerConnect firmware emulates industry standard behavior for enable
mode authentication over SSH and telnet. The default enable authentication
method for telnet and SSH uses the enableNetList method, which requires an
enable password. If users are unable to enter privileged mode when accessing
the switch via telnet or SSH, the administrator will need to either change the
enable authentication method, e.g. to enableList, or set an enable password.
If the encrypted parameter is specified, the password parameter is stored as
entered in the running-config. No attempt is made to decode the encrypted
password.
Example
The following example defines password "xxxyyyzzz" to control access to user
and privilege levels.
console(config)# enable password xxxyyyzzz

ip http authentication

Use the ip http authentication command in Global Configuration mode to
specify authentication methods for http server users. To return to the default,
use the no form of this command.
Syntax
ip http authentication
no ip http authentication
method1 [ method2 ...] — Specify at least one from the following table:
•
Keyword
local
none
radius
tacacs
method1 method2
[
Source or destination
Uses the local username database for authentication.
Uses no authentication.
Uses the list of all RADIUS servers for authentication.
Uses the list of all TACACS+ servers for authentication.
...]
AAA Commands
261