Provisioning Mrcp Tts Servers; Provisioning Mrcp Tts Default Genders; Configure The Default Tts Provider For The Crs System - Cisco CRS-1 - Carrier Routing System Router Administration Manual

Chapter 3 Provisioning Telephony and Media
Provisioning MRCP TTS Providers
Note
Step 1
Step 2
• Provisioning MRCP TTS Servers, page 3-30
Provisioning MRCP TTS Default Genders, page 3-32
•
Configure the Default TTS Provider for the CRS System, page 3-33
•
Use the MRCP TTS Providers Configuration web page to specify information
about the vendor of your TTS server.
After you update MRCP ASR/TTS Providers, Servers, and Groups, the
corresponding Provider needs to be Refreshed for changes to take effect. The CRS
Engine does not need to be restarted. However, during a Refresh, JTAPI triggers
using affected groups will fall back to the dialog group that is configured and the
MRCP Provider being refreshed will go OUT_OF_SERVICE until the reload is
complete.
Procedure
From the CRS Administration menu bar, choose Subsystems > MRCP TTS.
The MRCP TTS Providers List web page opens.
For a complete description of all columns, icons, and buttons on this page,
Note
see Chapter 15, "The Subsystems Menu."
Click the Add MRCP TTS Provider hyperlink.
The MRCP TTS Provider Configuration web page opens.
Cisco Customer Response Solutions Administration Guide, Release 4.1(1)
Provisioning ASR and TTS in Cisco CRS
3-29