Advertisement
Installing, Launching, and Connecting Network
Assistant
This chapter describes what you need to install Network Assistant, how to install it, how to launch it,
and how to connect it to a device or an existing community.
Installation Requirements
The PC on which you install Network Assistant must meet these minimum requirements:
•
•
•
•
•
•
Network Assistant is supported on these operating systems:
•
•
•
•
Network Assistant on Windows 98 cannot manage Catalyst 4500 series switches.
Note
Installing Network Assistant
To install Network Assistant on your PC, follow these steps:
OL-6194-02
Processor speed: 1 GHz
DRAM: 256 MB
Hard-disk space: 200 MB recommended (the actual application requires around 70 MB)
Number of colors: 65536
Resolution: 1024 x 768
Font size: Small
Windows XP, Service Pack 1 or later
Windows 2000, Service Pack 3 or later
Windows NT 4.0, Service Pack 6 or later
Windows 98, second edition
Go to this web address: http://www.cisco.com/go/NetworkAssistant.
1.
You must be a registered Cisco.com user, but you need no other access privileges.
Find the Network Assistant installer, cna-windows-k9-installer.2-0.exe.
2.
C H A P T E R
Getting Started with Cisco Network Assistant
3
3-1
Advertisement
Table of Contents
Related Manuals for Cisco and Connecting Network Assistant
Summary of Contents for Cisco and Connecting Network Assistant
-
Page 1: Installation Requirements
Installing, Launching, and Connecting Network Assistant This chapter describes what you need to install Network Assistant, how to install it, how to launch it, and how to connect it to a device or an existing community. Installation Requirements The PC on which you install Network Assistant must meet these minimum requirements: Processor speed: 1 GHz •... - Page 2 Getting Started with Cisco Network Assistant Chapter 3 4-4. When you click Connect, you are either connected to the 4-5. Connect Window Installing, Launching, and Connecting Network Assistant Figure 3-1. In it, enter the “Converting a Cluster to a Community” OL-6194-02...
- Page 3 Chapter 3 Installing, Launching, and Connecting Network Assistant Connecting Network Assistant to a Community or a Cluster When the connection occurs, the Network Assistant window is in connect mode. The toolbar adds icons that represent device features. Similarly, the feature bar fills with menus that list the device features that Network Assistant manages.
- Page 4 Chapter 3 Installing, Launching, and Connecting Network Assistant Connecting Network Assistant to a Community or a Cluster Getting Started with Cisco Network Assistant OL-6194-02...
Need help?
Do you have a question about the and Connecting Network Assistant and is the answer not in the manual?
Questions and answers