Managing System Parameters - Cisco CRS-1 - Carrier Routing System Router Administration Manual

Managing System Parameters

Step 16
Step 17
Step 18
Managing System Parameters
Step 1
Step 2
Field
1
RMI Port
Max Number of Executed
Steps
Cisco Customer Response Solutions Administration Guide, Release 4.1(1)
8-32
If you are using an Unified CCX system, you must perform two additional steps:
Identify the supervisor or agent phone as a Unified CCX phone (see
a.
Assigning Unified CM Users as Unified CCX Agents, page
Associate each agent and supervisor extension with the Cisco CRS RM JTAPI
b.
provider by using the Unified CM user page (see
Extensions with the RM JTAPI Provider, page
Verify the state of the subsystems by accessing the Cisco CRS Control Center
(System > Control Center).
Verify the functionality of the system by placing test calls.
You have now completed the LDAP migration process.
Use the System Parameters web page to configure system parameters such as port
settings, and set the default session timeout.
Procedure
Choose System > System Parameters from the CRS Administration menu bar.
The System Parameters Configuration web page appears.
Specify the following:
Description
The port number used by the CRS Engine to serve RMI requests.
Default: 1099
The maximum number of steps an application can execute before the
CRS Engine terminates the script or application.
This limitation is intended to prevent a script from running indefinitely.
Default: 1000
Note Do not change the default value.
Chapter 8 Managing the Cisco CRS System
4-11).
Associating Agent
4-6).