Ipv6 Tftp; Ipv6 Telnet - H3C S5100-SI Series Operation Manual

Operation Manual – IPv6 Management
H3C S5100-SI/EI Series Ethernet Switches
Follow these steps to traceroute IPv6:
To do...
Traceroute IPv6

2.2.3 IPv6 TFTP

IPv6 supports Trivial File Transfer Protocol (TFTP). As a client, the device can
download files from or upload files to a TFTP server. For details about TFTP, see
FTP-SFTP-TFTP Operation.
I. Configuration preparation
Enable TFTP on the TFTP server and specify the path to download or upload files. For
specific operations, refer to TFTP server configuration specifications.
II. IPv6 TFTP configuration
Follow these steps to download or upload files to TFTP servers:
Download/Upload files
from TFTP server
Caution:
When you use the tftp ipv6 command to connect to the TFTP server, you must specify
the "–i" keyword if the destination address is a link-local address.

2.2.4 IPv6 Telnet

Telnet protocol belongs to application layer protocols of the TCP/IP protocol suite, and
is used to provide remote login and virtual terminals. The device can be used either as
a Telnet client or a Telnet server.
As the following figure shows, the Host is running Telnet client application of IPv6 to set
up an IPv6 Telnet connection with Device A, which serves as the Telnet server. If
Device A again connects to Device B through Telnet, the Device A is the Telnet client
and Device B is the Telnet server.
Use the command...
tracert ipv6 [ -f first-ttl | -m
max-ttl | -p port | -q packet-num |
-w timeout ]* remote-system
To do...
tftp ipv6 remote-system
[ -i interface-type
interface-number ] { get |
put } source-filename
[ destination-filename ]
Chapter 2 IPv6 Application Configuration
Use the command...
2-3
Remarks
Required
Available in any view
Remarks
Required
Available in user view