Logging In Through Nms; Introduction; Connection Establishment Using Nms - H3C S5600 Series Operation Manual

6

Logging In Through NMS

Go to these sections for information you are interested in:

Introduction

Connection Establishment Using NMS

Introduction
You can also log in to a switch through a network management station (NMS), and then configure and
manage the switch through the agent module on the switch. Simple network management protocol
(SNMP) is applied between the NMS and the agent. Refer to the SNMP-RMON part for related
information.
To log in to a switch through an NMS, you need to perform related configuration on both the NMS and
the switch.
Table 6-1 Requirements for logging in to a switch through an NMS
Item
Switch
NMS
Connection Establishment Using NMS
Figure 6-1 Network diagram for logging in through an NMS
Network
NMS
The IP address of the VLAN interface of the switch is configured. The route between the NMS
and the switch is reachable. (Refer to the IP Address Configuration – IP Performance
Configuration and Routing Protocol parts for related information.)
The basic SNMP functions are configured. (Refer to the SNMP-RMON part for related
information.)
The NMS is properly configured. (Refer to the user manual of your NMS for related
information.)
Switch
Requirement
6-1