Connection Establishment Using Nms; Chapter 6 Logging In Through Nms - H3C S5600 Series Operation Manual

Hide thumbs Also See for H3C S5600 Series:

Table of Contents

Operation Manual – Login

H3C S5600 Series Ethernet Switches

Go to these sections for information you are interested in:

Introduction

Connection Establishment Using NMS

6.1 Introduction

You can also log in to a switch through a network management station (NMS), and then

configure and manage the switch through the agent module on the switch. Simple

network management protocol (SNMP) is applied between the NMS and the agent.

Refer to the SNMP-RMON part for related information.

To log in to a switch through an NMS, you need to perform related configuration on both

the NMS and the switch.

Table 6-1 Requirements for logging in to a switch through an NMS

6.2 Connection Establishment Using NMS

Figure 6-1 Network diagram for logging in through an NMS

The IP address of the VLAN interface of the switch is configured. The

route between the NMS and the switch is reachable. (Refer to the IP

Address Configuration – IP Performance Configuration and Routing

Protocol parts for related information.)

The basic SNMP functions are configured. (Refer to the SNMP-RMON

part for related information.)

The NMS is properly configured. (Refer to the user manual of your

NMS for related information.)

Chapter 6 Logging In Through NMS

Table of Contents