Configuring Line Rate; Configuring Traffic Redirecting - H3C S5600 SERIES Operation Manual

Configuring Line Rate

Refer to section
Configuration prerequisites
The port on which line rate configuration is to be performed has been determined.
The target rate has been determined.
Configuration procedure
Follow these steps to configure line rate:
To do...
Enter system view
Enter Ethernet port view
Configure line rate
Configuration example
# Set the line rate to 1024 kbps for outbound packets on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet1/0/1
[Sysname-GigabitEthernet1/0/1] line-rate outbound 1024

Configuring Traffic Redirecting

Refer to section
Configuration prerequisites
The ACL rules used for traffic classification have been defined. Refer to the ACL
module of this manual for information about defining ACL rules.
The traffic redirecting destination has been determined.
The ports that need this configuration have been determined.
Configuration procedure
Follow these steps to configure traffic redirecting:
Line Rate for information about line rate.
Use the command...
system-view
interface interface-type
interface-number
line-rate outbound
target-rate [ burst-bucket
burst-bucket-size ]
Traffic Redirecting for information about traffic redirecting.
1-20
Remarks
—
—
Required
Specify a committed
information rate (CIR) for
the target-rate argument,
and specify a committed
bust size (CBS) for the
burst-bucket-size
argument.
By default, line rate is
disabled.