Configuring Traffic Redirecting - H3C S5100-SI Series Operation Manual

The target rate and the direction (inbound or outbound) of line rate have been
determined.
II. Configuration procedure
Follow these steps to configure line rate:
To do...
Enter system
view
Enter Ethernet
port view
Configure line
rate
III. Configuration example
# Configure line rate for the incoming packets on GigabitEthernet 1/0/1, with the rate
limit being 1024 kbps.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] line-rate inbound 1024

1.4.9 Configuring Traffic Redirecting

Refer to
Note:
This feature is available only on the H3C S5100-EI series switches.
I. Configuration prerequisites
The ACL rules used for traffic classification have been defined. Refer to the ACL
module of this manual for information about defining ACL rules.
The port that the ACL matching packets are to be redirected to has been
determined.
II. Configuration procedures
You can configure traffic redirecting for incoming packets globally, in a VLAN, in a port
group, or on a port.
1) Configuring traffic redirecting globally
Use the command...
system-view
interface interface-type
interface-number
line-rate { inbound |
outbound } target-rate
Traffic Redirecting for information about traffic redirecting.
—
—
Required
Disabled by default.
1-33
Remarks