Displaying Protocol-Based Vlan Configuration; Protocol-Based Vlan Configuration Example - H3C S5600 SERIES Operation Manual

To do...
Enter system view
Enter port view
Associate the port with the
specified protocol-based
VLAN

Displaying Protocol-Based VLAN Configuration

Display the information about the
protocol-based VLAN
Display the protocol information and
protocol indexes configured on the
specified VLAN
Display the protocol information and
protocol indexes configured on the
specified port

Protocol-Based VLAN Configuration Example

Network requirements
As shown in
S5600 switch.
IP network and AppleTalk network workstations (hosts) coexist in the Workroom.
The S5600 switch connects to VLAN 100 (using IP network) through GigabitEthernet 1/0/11 and to
VLAN 200 (using AppleTalk network) through GigabitEthernet 1/0/12.
Configure the switch to automatically assign the IP and AppleTalk packets to proper VLANs for
transmission, so as to ensure the normal communication between the workstations and servers.
Use the command...
system-view
interface interface-type
interface-number
port hybrid protocol-vlan vlan
vlan-id { protocol-index [ to
protocol-index-end ] | all }
To do...
Figure 2-2, Workroom connects to the LAN through port GigabitEthernet 1/0/10 on the
Use the command...
display vlan [ vlan-id [ to vlan-id ] | all |
dynamic | static]
display protocol-vlan vlan { vlan-id [ to
vlan-id ] | all }
display protocol-vlan interface
{ interface-type interface-number [ to
interface-type interface-number ] | all }
2-9
Remarks
—
—
Required
By default, a port is not
associated with any
protocol-based VLAN.
Remarks
Available in
any view