Operation Manual – VLAN
H3C S5100-SI/EI Series Ethernet Switches
Associate the port with
the specified
protocol-based VLAN
2.3.4 Displaying Protocol-Based VLAN Configuration
Display the information about the
protocol-based VLAN
Display the protocol information
and protocol indexes configured
on the specified VLAN
Display the protocol information
and protocol indexes configured
on the specified port
2.3.5 Protocol-Based VLAN Configuration Example
I. Network requirements
As shown in
GigabitEthernet1/0/10 on the S5100-SI/EI switch.
IP network and AppleTalk network workstations (hosts) coexist in the Workroom.
The S5100-SI/EI switch connects to VLAN 100 (using IP network) through
GigabitEthernet1/0/11 and to VLAN 200 (using AppleTalk network) through
GigabitEthernet1/0/12.
Configure the switch to automatically assign the IP and AppleTalk packets to
proper VLANs for transmission, so as to ensure the normal communication
between the workstations and servers.
To do...
port hybrid protocol-vlan
vlan vlan-id { protocol-index
[ to protocol-index-end ] | all }
To do...
Figure
2-2, Workroom connects to the LAN through port
Use the command...
Use the command...
display vlan [ vlan-id [ to vlan-id ]
| all | dynamic | static]
display protocol-vlan vlan
{ vlan-id [ to vlan-id ] | all }
display protocol-vlan interface
{ interface-type interface-number
[ to interface-type
interface-number ] | all }
2-10
Chapter 2 VLAN Configuration
Remarks
Required
By default, a port is not
associated with any
protocol-based VLAN.
Remarks
Available in
any view