urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 95

As the local configuration has been modified with the "Modify" button, this is highlighted on the "Site" tab,
as shown in the figure above: the modification date of the project is more recent than the modification
date of the system site. This means that the configuration is not aligned (red boxes).
Local configuration modification requires the installer password, set through the configurator the
first time the configuration has been created.
Connection to the system site may require the administrator password if the system is blocked, or
the Urmet password if the system is unlocked.
The "Configuration" tab instead shows that the system devices have an older configuration than the project
(as shown in the red box):
Figure 76: "Configuration" tab with local configuration not yet transferred to the system
The "Apply changes" button allows you to align the configuration: in fact (after applying the changes) the
"Modified" field on the "Site" tab is the same both on the project and on the system site and therefore the
configuration is aligned. In the "Configuration" tab, the "Devices from factory or with an older
configuration" field is reset to zero, while the "Devices with the same configuration" field takes the same
value as the system devices (with the same configuration associated to the project):
MT124-032M 95