urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 193

Simply select the device to add, identifying it through its MAC address, and it is filled in automatically.
If you are connected to a system with one or more Servers 1060/1, they must be configured if you
want to save the system configuration. Otherwise, it is impossible to save the configuration and the
configurator shows the message below:
This is to avoid starting a system with Servers 1060/1 connected but not configured: the concerned system
will not operate properly.
7.1.2.1 Adding a Gateway IPerCom-2Voice on a stair node
If a Gateway IPerCom-2Voice 1083/59 has been added on a stair node with one of the methods described
above, the configurator has some differences compared to the addition of other devices. The addition of a
Gateway IPerCom-2Voice 1083/59 on a stair node highlights the fact that on that stair node you want to
install a riser column of 2Voice audio / video apartment stations. To distinguish the stairs with IPerCom
audio / video apartment stations from the 2Voice stairs, these ones and all their underlying nodes are
highlighted in yellow in the configurator's navigation module:
Figure 229: Stairs where a Gateway IPerCom-2Voice is placed with underlying floors and apartments
MT124-032M
Figure 228: message when Servers 1060/1 are not configured
193