urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 456

8.4.2 Adding devices to the system using the MAX video door phone and/or the Android
tablet app
To add all the devices of the system to the configuration, it is advisable to follow one of the 4 procedures
below. In this way, you can speed up the configuration operations by exploiting some features of the MAX,
7
VOG or Basic video door phones and the Android tablet app.
The examples below refer to the MAX 1717/3x-4x video door phone, but what is stated is valid for all other
7
MAX 1717/2x, VOG or Basic video door phones.
8.4.2.1 Mode 1: installer uses only MAX video door phones for the system configuration
Application case: The devices are already installed on the system, but not yet configured
Pros: Only MAX video door phones are required; there is no need of an Android PC or
tablet; you do not need to know the physical MAC addresses of your MAX video
door phones
Cons: Requires to enter the installer password and open the configurator from one device
at a time; requires knowledge of the MAC addresses of all other devices in the
system.
In this case, it is assumed that the system is already installed. The installer uses one of the MAX video door
phones and starts creating the configuration project as explained below.
1. Adding the first MAX video door phone to the configuration
For example, if you create a Single Stair configuration on a system MAX video door phone, the first step is to
add such device to the relevant topological node. Then it is necessary to go to the "Devices" tab and click
on the "Add new device" button.
456
Figure 609: Adding a new device
MT124-032M