The name of the site is the one that will then appear in the IPerCom Installer Tools application in the
"Site" tab in the relevant "Site Name" field, after aligning the project configuration with that of the
system.
To enter the name of the project and the installer password use the alphanumeric keyboard present
in the configurator. Special characters (for example the ''emoticons'') may not be displayed
correctly (also on Call Module or Switchboard or Modular entry panel with 1060/48). It is therefore
advisable to check the correct display of the characters on the system devices and configurator at
the end of the configuration.
If, instead of creating a new configuration, you want to modify an existing one, the configurator is
opened with the configuration present on the system, after entering the installer password.
As for the choice of the plant model, there are 4 options available, depending on your needs:
1. Villa Kit (one-household)
2. Single Stair
3. Multiple Stairs
4. Multi Block
The choice of a plant model rather than another determines the topological structure of the plant model
itself and the behaviour of the network interfaces of the MAX video door phones in the system; if you are
not sure of the choice, we recommend to select the most generic model, i.e. Multi Block.
As for the plant models Multiple Stairs and Multi Block, these are the only ones that allows placing both
secondary and primary Call Modules.
The Kit Villa (single-family) model, on the other hand, is the only one that allows video door phones to
access the Internet via the ETH0 network interface, which is not normally used for this purpose. For the
other system models, the video door phones access to the Internet via the ETH1/WiFi network interfaces (if
present).
The ETH1/WiFi interfaces (used by third-party apps on the video door phones to access the Internet)
must never be connected to networks without Internet access as this compromises the device's call
forwarding performance.
MT124-032M
173
Need help?
Do you have a question about the IPerCom 3.0.0 and is the answer not in the manual?