urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 522

End-user settings
Switchboard Button
Infrared
LEDs
Keyboard LEDs
Call Feedback Tone
Button Feedback Tone
Speakers Volume
Welcome Message
RTSP stream on call settings
RTSP stream on call
IP Address (#)
Network mask (#)
Port
Stream
User Name (#)
Password (#)
Streaming URI
522
Enable button to call to the respective Switchboard.
Enabling of user presence competence through integrated
infrared sensor.
Enabling of the camera LED.
Enabling the keypad backlighting.
Call feedback setting.
Setting of audio feedback on buttons.
Loudspeaker volume setting
This allows you to set a welcome message on the Call
Module display. Some special characters (e.g. "emoticons")
may not be displayed correctly, so we recommend that you
check that the message is displayed correctly. Maximum
length of the message: 64 characters.
Table 29: End-user settings
If selected, the Switchboard application can display the RTSP
video stream of the calling station during the call to an
apartment station or during the auto-on from an apartment
station. Fields marked with the hash mark (#) must be filled
correctly.
IP address of calling station camera.
Subnet mask of RTSP cameras (including calling station
camera).
RTSP video stream port. Value not editable.
Name of the RTSP video stream. Value not editable.
Username to access the calling station RTSP video stream
from the Switchboard application.
Password to access the calling station RTSP video stream
from the Switchboard application.
Full URI of the RTSP video stream. Value not editable.
It is built automatically by filling in the fields above respecting
the following syntax:
rtsp://[<username>:<password>@] <IP
address>:<port>/<stream>
Table 30: RTSP streaming settings
MT124-032M