urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 463

8.4.2.3 Mode 2: The installer creates the configuration in the laboratory on the MAX video door
phone/PC/Android tablet but adds the devices via Android tablet
Application case: The devices are already installed on the plant, but not yet configured. There is a
basic configuration on SD Card in which the topology has been defined but the
devices have not been added yet. You have an Android tablet with the IPerCom
Configurator app installed on it.
Pros: It is possible to create the topology in the laboratory through MAX video door
phone/Android tablet and add devices (of any type) in the field by simply scanning
the QR Code.
Cons: An Android tablet is required
The following mode takes advantage of the IPerCom devices feature to show a QR Code that contains its
MAC address: in the case of MAX video door phones the QR Code is displayed when not configured,
whereas in other devices it is shown frontally on a label.
1. Configuration creation (topology only) in the laboratory and saving on Android tablet
The installer creates the configuration in the laboratory on the MAX video door phone/PC/Android tablet by
setting only the system topology. If you have used a MAX video door phone or a PC, the configuration must
then be copied to an Android tablet (e.g. by saving it on an SD card).
2. Adding devices to the configuration by scanning the QR Code
The installer goes to the area where the system is already installed and brings with him/her an Android
tablet containing the configuration.
Once the project saved on the tablet has been opened, the installer moves to each device of the system
and adds it to the configuration as described below.
First, in the Topology tab it is necessary to go to the topological node of the device to be added, then in the
context module you must select the "Devices" tab and press on "Add new device".
At this point, as already described, you select the type of device to add and fill in the fields shown on the
screen, as usual: the only difference is the possibility, for Android tablets, to enter the MAC address by
scanning the QR Code of the device, by pressing the "QR Code" button.
MT124-032M 463