urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 48

6 Commissioning a system through IPerCom Installer Tools
6.1 Introduction to IPercom Installer Tools
The IPerCom Installer Tools application can be downloaded from
(Software -> Technical software -> Communication -> IPerCom system). To access the software, download
area, registration to the website is required.
Hardware and software minimum requirements for installation are the following:
•
Windows 7, 8, 10, 11 operating system with quad core CPU and frequency greater than 2GHz;
•
SSD disk with 512GB or higher capacity (no hard disk);
•
8GB or higher RAM memory;
•
10/100/1000 Mbit/s network card.
For each officially released version of IPerCom (starting from version 1.1.0) there is the corresponding
version of IPerCom Installer Tools, as the versions of a system and IPerCom Installer Tools must always be
aligned.
The application allows the commissioning of an IPerCom system and at the same time features a set of
additional functions which make it an indispensable tool for system configuration and maintenance. All
these functions will be explained in detail later in this manual: in this introductory chapter it is sufficient to
underline that in IPerCom Installer Tools the system you want to configure (by system meaning the entire
network, devices and IPerCom software applications) is called a site.
It is possible to assign a name to the site (via the configurator of IPerCom Installer Tools). This is a
fundamental data because it allows the site to be uniquely recognized in all the possible applications in
which it is involved:
- the configurator, where when creating a new project, you must enter the name of the site;
- IPerCom Installer Tools, where the name of the site given in the configurator is visible in the "Site"
tab on the right side of the screen,
- CallMe Manager, where the name of the site appears in the list of sites managed by the building
manager.
The 3 points above are illustrated in detail in
definition.
On IPerCom Installer Tools in the "Site" tab, it is possible to check the alignment status between the
configuration relating to a project and the configuration present on the site (plant), highlighting the
following possible situations:
•
site configuration aligned with that present in the project (same date and time);
•
site configuration older than that present in the project;
•
site configuration newer than the one present in the project.
48
www.urmet.com
APPENDIX N: "Site name" and "Global site ID" field
in the download area
MT124-032M