urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 493

4. In the selected node, add an iPerTalk Server by correctly setting the MAC address of the device
(manually).
5. Navigating in the apartments of "Floor 1" (in this case where the iPerTAlk Server V1 has been
inserted), following the example above, on the "Settings" tab, enable "iPerTalk" and insert the
number to call (iPerTalk ID) (e.g. 90101, 90102, 90103, etc.). By enabling the iPerTAlk parameter,
the apartment is considered as an extension in the iPerTAlk system. Depending on how the system
is structured, it may be necessary to configure a number of apartments equal to the number of
extensions to be called from the IPerCom system. All apartments configured as iPerTAlk extensions
will be displayed in the Ipercom device directoryconfigurati come derivati interni iPerTAlk verranno
visualizzati nella rubrica dei dispositivi Ipercom.
6. Proceed with the configuration of the door units and other IPerCom devices.
MT124-032M
Figure 652: Example of iPerTAlk Server insertion
Figure 653: iPerTAlk ID configuration
493