urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 363

7.1.10.5 Network settings
The parameters are shown in the following figure:
The parameter meaning is as follows:
N
ETWORK SETTINGS
Network Settings
DNS
After a change in network settings (from automatic to manual or vice versa), it is recommended
(after the configuration distribution) to restart all switches in the system. If this is carried out
through a main switch, make sure that the Server 1060/1 is connected to a UPS (uninterruptible
power supply) device, to avoid irreparable damage caused by a sudden power failure. In the
absence of UPS, it is necessary to turn off the Server 1060/1 through the dedicated button and then
turn it on again after restoring power supply to the system. Restarting the switches (in the same
way as described above when there is a main switch) is recommended if a router with DHCP service
is added to the system or removed from the system.
After a change in network settings, any devices in the system with a static IP address (e.g. RTSP
cameras) must be made compatible with the new address assigned to the system.
MT124-032M
Figure 479: "System" tab – RTPS Network settings
The "automatic" value means that the devices automatically
acquire an IP address consistent with the network in which
they are installed (networks with router and DHCP server or
wiyhout); the "manual" value allows setting the network
parameters according to your needs and according to the
network in which the system is installed (networks without
router with DHCP server).
IP addresses of the DNS server (default value: 8.8.8.8)
Table 20: Network parameters and their meaning
363