urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 600

Case 2: IPerCom system with router and automatic addressing
The RTSP Cameras have already been configured with static IP addressing (e.g. 10.2.3.100, 10.2.3.101,
10.2.3.102). In the System tab of the configurator in the Network Settings section, select Automatic, then
set the router so that it assigns IP addresses to IPerCom devices in a certain range. The only 2 constraints to
be respected are the following:
•
the IP address assignment range for IPerCom devices must be outside the IP addresses of the RTSP
cameras (e.g. from 10.2.3.2 to 10.2.3.99);
•
the IP addresses of IPerCom devices and RTSP cameras must be in the same subnet.
Then the installer will write the previously proposed static IP address in the page of the RTSP Camera of the
configurator. In this case it is not necessary to set the RTSP Network Settings section, also because the
static IP addresses proposed by the configurator may not coincide with those already defined.
600 MT124-032M