urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 89

The green section shows schematically the condition of all the devices connected to the system. The
example in question shows that:
•
the number of devices connected to the system ("Involved devices") is 6;
•
the number of devices not in configuration is 6.
The configuration status is not aligned (red section), as explained above.
To apply the previously created configuration to the devices of the system, it is necessary to press the
"Apply Changes" button.
In this way the configuration associated to the project is transferred to the system site. The correct
configuration transfer is highlighted by a light blue progress bar that turns when the transfer is successful,
as shown below:
The red boxes indicate that the configuration transfer has taken place correctly, i.e.:
•
all devices in the system have the same configuration ("Devices with the same configuration" item);
•
the configuration status is aligned.
Once the configuration has been applied, the "Last modified" field is renamed to "Applied" and
shows the date and time in which the configuration was applied (or modified) to the system.
MT124-032M
Figure 68: local configuration transferred to the system
89