urmet domus IPerCom 3.0.0 System Technical Manual For The Installer page 79

6.10 How to use IPerCom Installer Tools for the configuration of a system
Below is the description of the various steps to follow to configure a site (system) with IPerCom Installer
Tools and how the application parameters listed in the previous paragraph vary. The most common ways to
configure an IPerCom system are shown below (assuming the system has already been installed and wired).
6.10.1 Mode 1: system installed but not configured, creation of configuration associated to the
project without connection to the system
The various devices that make up the system have been installed and wired but have not been configured,
that is the system has no configuration file. The steps to configure the system are described below:
•
create a new project and the related configuration;
•
connect to the system;
•
set the proper system date and time;
•
apply the newly created configuration to the system.
This is a practical example of use, as the installer usually creates the configuration in the laboratory, then
goes to the system, where the devices have already been installed, connects to the system, and distributes
the configuration. It is necessary to know the MAC addresses of the devices to be added to the
configuration and the system topology, that is to know on which nodes the devices must be positioned.
6.10.2 Mode 2: system installed but not configured, creation of configuration associated to the
project with connection to the system
The various devices that make up the system have been installed and wired but have not been configured,
that is the system has no configuration file. The steps to configure the system are described below:
•
create a new project and the related configuration, being connected to the system itself;
•
set the proper system date and time;
•
apply the newly created configuration to the system.
In this way of proceeding, it is not necessary to know the MAC addresses of the various devices (when
creating the configuration) as these are automatically suggested by the configurator, which is not the case
if you are not connected to the system. This will be described in more detail in paragraph
configurator". Instead, it is always necessary to know the system topology, that is to know on which nodes
the devices must be positioned.
MT124-032M
"The
79