Table of Contents
Advertisement
3. VT100 Interface
TFTP Configuration
A Trivial File Transfer Protocol (TFTP) service on a server can provide remote file
access to the 8300 Endpoint to
To transfer a file to or from a TFTP server from a unit, you must indicate the TFTP
server's IP address and file name, and then perform a Get operation to receive a
file from the server, or a Put operation to send a file to the server. The file name
and its extension determine the type of file transferred.
The table below shows the possible file operations.
Note that when updating the application software using a .HEX file, the file name
should have the form xxAPxxxx.HEX; the AP indicates the file is an application
load. When updating the boot software, the file name should have the form
xxWBxxxx.HEX; the WB indicates the file is a boot load.
Figure 3-65. TFTP Configuration Screen
TFTP Server IP
IP address of the server providing TFTP access.
Address
File Name
Name of the file to be transferred.
3-72
Update the firmware on an 8300 Endpoint
Save the configuration setup of a unit
Restore a saved configuration setup to a unit
Operation
Update Application Firmware
Update Boot Firmware
Save Configuration Setup
Restore Configuration Setup
April 2003
File Name Extension
Action
.CHX or .HEX(1)
Get
.HEX(2)
Get
.CFG
Put
.CFG
Get
8300-A2-GB20-00
Advertisement
Table of Contents
