Table of Contents
Advertisement
3. VT100 Interface
Trap IP Address
Accepts the IP Address of a network device where alarm reporting traps are to be
sent.
Top Talkers
Selecting Top Talkers displays the Top Talkers screen
to set parameters for and initiate the generation of a list of IP Addresses ranked in
terms of the number of frames and octets they have transmitted during a specified
reporting period. This report allows MIS managers to determine who is generating
the most traffic on a WAN based on IP Addresses.
Figure 3-67. Top Talkers Screen
To generate a Top Talkers report, enter the duration parameters and desired report
size in the available fields as described below, and then press the Enter key or
select the Start prompt on the screen.
Duration (sec)
Establishes the amount of time (in seconds) for which the Top Talkers report will
capture IP traffic; typically this value is 900 seconds (15 minutes).
Requested Report
Establishes how many IP Addresses will be reported as the Top Talkers.
Size
NOTICE:
As soon as you initiate generation of a report by pressing the Enter key or
selecting the Start prompt, the Duration value is copied over to the Time
Remaining field. When the specified Duration for the report has elapsed, the
resulting report-specific information will be displayed on the left side of the screen.
Time Remaining
The amount of time (in seconds) for which the Top Talkers report will capture IP
traffic; typically this value is 900 (15 minutes). As soon as you initiate generation of
the report, the Duration value is copied over to the Time Remaining field.
3-74
While you may request any number, the unit is internally limited to a
maximum report size of 20.
April 2003
(Figure
3-67), which is used
8300-A2-GB20-00
Advertisement
Table of Contents
