Table of Contents
Advertisement
3. VT100 Interface
Figure 3-9.
This screen lets you configure or change the following information about the
selected configuration profile:
Profile Name
A 32-character string that identifies a Profile Name in the Span Profile table. Each
entry represents the complete span in an ATM line.
Wire Mode
Displays the type of wire interface used by the span). The 8300 Endpoint supports
only the two-wire mode.
Data Rate (Min)
Sets the minimum attainable data rate in the span.
Data Rate (Max)
Sets the maximum attainable data rate in the span. Note that the line rate will be 8
kbps above the data rate.
Remote
Enables/disables support for remote management of the units in an SHDSL line
from the STU-R via the EOC.
Transmission Mode
Sets the regional setting of the span represented as a bit-map of possible settings.
NOTICE:
3-10
Configuration Profile Details Screen
Values: Enabled, Disabled
Default: Enabled
Values: Annex-A (ITU-T G.991.2) , Annex-B (ITU-T G.991.2)
Default: Annex-B
When the 8300 Endpoint is operating with Unit Type set to TU-R, it
supports Annex-A or Annex-B. The configuration of the TU-C unit
determines the actual transmission mode used.
April 2003
8300-A2-GB20-00
Advertisement
Table of Contents
