Table of Contents
Advertisement
3. VT100 Interface
Figure 3-27. Service Details Screen
From this screen, you can access and change the parameters listed below. The
new parameters are saved when you press the Esc key and return to the previous
screen.
Interface
Selecting one of the interfaces will bring up a screen where you can view interface
parameters. These screens are the same ones displayed when you select a
sub-menu from the Interfaces screen described earlier on page 3-6.
Type
Selecting one of the services listed under the Type column will bring up a screen
where you can view (and, in some cases, change) parameters for each type of
service. The details displayed depend on the type of service currently in effect.
These screens are shown and described below according to each type of service.
IP Service Details Screen
The IP Service Details screen
<Type> column in the IP Service screen, lets you configure the IP parameters
described on page 3-26.
To change any of the available parameters, you must enter new values in the
appropriate field(s) and press the Esc key to save your changes.
NOTICE:
ATM Service Details Screen
Access the ATM Service Details screen
under the Type column on the Services screen. The ATM Service Details screen
lets you access the configuration parameters described in the paragraphs below.
3-30
(Figure
To use newly established IP parameters, you must Save and
Restart. (See
Save and Restart
April 2003
3-22), accessed by selecting IP from the
on page 3-6.)
(Figure
3-28) by selecting the ATM link
8300-A2-GB20-00
Advertisement
Table of Contents
