Paradyne CopperJet 810 Installation Instructions

Bridge/router mounting bracket installation to a wall

Download this manual

CopperJet 810 Mounting Bracket

Installation Instructions

Document Number 4800-A2-GN13-00

September 2002

The CopperJet 810 mounting bracket (Feature Number 4800-F1-013) can be used to

fasten the CopperJet 810 Bridge/Router to a wall, or to the side or underside of a desk.

Installing the Bracket on Wall or Side of Desk

Procedure

To attach the mounting bracket to a wall or to the side of a desk:

1. Fasten either side of the bracket to the wall or desk where the CopperJet 810 is to

be installed. Use screw anchors (not provided) in drywall or other soft materials.

Page 1 To attach the mounting bracket to a wall or to the side of a desk: 1. Fasten either side of the bracket to the wall or desk where the CopperJet 810 is to be installed. Use screw anchors (not provided) in drywall or other soft materials.
Page 2 Installing the Bracket on Underside of Desk Procedure To attach the mounting bracket to the underside of a desk or other piece of furniture: 1. Fasten the top of the bracket to the surface the CopperJet 810 is to hang from.
Page 3 Installing the CopperJet 810 in the Bracket Procedure To install the CopperJet 810 in the bracket: 1. Connect all required cables to the CopperJet 810 before installing it in the bracket. 2. Slide the CopperJet 810 upward into the bracket with the faceplate against the bracket.
Page 4: Document Feedback
Document Feedback We welcome your comments and suggestions about this document. Please mail them to Technical Publications, Paradyne Corporation, 8545 126th Ave. N., Largo, FL 33773, or send e-mail to userdoc@paradyne.com. Include the number and title of this document in your correspondence. Please include your name and phone number if you are willing to provide additional information.