Maintenance Reset - Paradyne Hotwire 8300 User Manual

Maintenance Reset

Select the Maintenance Reset field and press Enter. To select between the
different factory configurations, press the space bar. All configurations will be lost
and the unit will be set back to an initial factory configuration. There are five
options for a Maintenance Reset as shown in the table below.
RFC 1483
Configuration Encapsulated
Choice Data
Ethernet Yes
Serial HDLC Yes
T1 CBR* Yes
E1 CBR Yes
Serial CES Yes
Configuration
* Factory default configuration
All the factory configurations set up an ATM service on the Network port with one
configured virtual channel (VPI=0, VCI=32). Management data received on this
channel (either WEB or SNMP) will be processed at the unit if it is encapsulated
using RFC 1483 and directed to the unit's IP address. (A Maintenance Reset will
not change the unit's IP address.)
The Serial HDLC configuration and the T1 CBR configuration will also accept
PPPoA encapsulated data and deliver it to the Serial port.
The T1 CBR, E1 CBR, and Serial CES configurations set up a CES service
between the Network port and the T1/E1 CBR port or the Serial port using VPI=0,
VCI=33. The T1 CBR configuration sets up the CBR port to run T1 and has 24
channels delivered to the CES service. The E1 configuration sets up the CBR port
to run E1 and has 31 channels delivered to the CES service. The Serial CES
configuration sets up the CBR port to run E1, but allocates Channels 1
Serial port.
Selecting the Maintenance Reset field will display a selection screen where you
can toggle (using the spacebar) among available configurations as shown in
Figure
Figure 3-4.
8300-A2-GB20-00
IP Serial HDLC
Encapsulated Encapsulated
in ATM in ATM
Yes No
No Yes
No Yes
Yes No
Yes No
3-4.
Maintenance Reset Screen
April 2003
T1 CBR E1 CBR
Channels Channels
None None
None None
1 2 4 None
−
None 1 3 1
−
None None
3. VT100 Interface
Serial CBR
Channels
None
None
None
None
1 3 1
−
3 1 to the
−
3-5