Table of Contents
Advertisement
Route Status
Indicates whether or not the current route is enabled.
D y n a m i c R o u t e T a b l e S c r e e n
Access this menu
Gateway menu and then selecting Dynamic Route Table. This table shows both
dynamic and circuit tables. Please note that not all parameters are necessarily
defined, depending on whether or not the routes were learned dynamically.
Primarily, the most useful information is included in "Destination," "If Ndx," and
"Mask" columns.
Figure 3-46. Dynamic Route Table Screen
The Dynamic Route Table displays the fields listed below.
Static ARP Table Screen
ARP (Address Resolution Protocol) is used by the router to dynamically associate
a high-level IP Address to a low-level physical hardware address. ARP packets
are only sent across a single physical network.
There are some cases when an IP-compatible device does not support ARP or
ARP is deliberately disabled (for security). In these cases, instead of using ARP to
dynamically update the router internal MAC <-> IP Address Table, this menu can
force an entry into that table. This entry never times out.
8300-A2-GB20-00
Values:Disable, Enable, Enable and Advertize
Default:Enable
(Figure
Field
Description
Destination
Network to be reached.
If Ndx
Interface internal number.
Next Hop
IP Address used to reach the destination network.
Mask
Mask of the destination network.
April 2003
3-46) by selecting the Static Route Table on the IP
3. VT100 Interface
3-55
Advertisement
Table of Contents
